|| Rate this content|
HP Designjet 450c Printers - Product Specifications
Serial number location
When looking at the back of the printer, the serial number is located on the right side of the rear panel, directly above the power cord.
The HP Designjet 450c printer is a color large format Inkjet printer that provides ease of use through features like improved media handling and a new front panel. It offers a new monochrome draft print mode to increase speed.
The HP Designjet 450c supports HP-GL, HP-GL/2, HP-RTL, PJL and includes AutoCAD drivers. Additional features include:
RS-232 and bidirectional with ECP mode (IEEE-1284) built in; I/O switching
The HP Designjet 450c printer supports the following media:
NOTE: For image printing purposes, some HP translucent bond, HP vellum, and HP natural tracing paper are not recommended.
Roll media should have an inner core diameter of 2 inches and an outer core diameter of 2.125 inches. The maximum diameter of the rolls is 3.8 inches. Roll widths can be 24 or 36 inches.
To see if your operating system is supported, check the Get drivers, manuals, parts & solutions page.
NOTE: All measurements are +/- 0.08 inch (2 mm).
The memory capacity of the HP Designjet 400 series printer is 36 MB. Four (4) MB of memory are built-in RAM on the main board. The remainder is available through one SIMM (single inline memory module) slot that can take either a 4 MB, 8 MB, 16 MB, or 32 MB SIMM card. The second SIMM socket is intended for code upgrades.
The HP Designjet 400 series printer is shipped with 4 MB of RAM on the main board as standard. Available memory is reduced by approximately 2 MB of "overhead" requirements; for example, stack space, the I/O buffer, and variable storage. A rough estimate of the ratio of user-to-DJ400 file storage is 0.8/1. File expansion in the HP Designjet 400 series printer buffer depends largely on file content. Labels, polygons, line widths greater than 1 mm, and raster data are examples of memory-eaters.
When receiving a print, the HP Designjet 400 series printer stores all the vector data and raster data in the memory buffer. If the buffer is full, remaining vector data is read in and discarded. If sending all raster data, the buffer is filled, then printed; plotting continues in this way until the print is complete.
NOTE: The 4 MB and 8 MB memory SIMM's are no longer available for the 450C printer. Available memory SIMM's for the 450C printer are listed below.
16MB, 70nS, 36-bit SIMM memory module - (D2297A)
32MB, 70nS, 36-bit parity SIMM memory module - (D3578A)
Click here to purchase parts and accessories from the HP Parts store at http://www.hp.com/buy/parts.
NOTE: Part numbers are subject to change. If searching for a specific part is unsuccessful, try searching for the printer or printer model (i.e Designjet 450c, C4715A). Doing so will generally provide navigation to all available parts for that product.
A1/D-size, Mono CAD drawing, HP Opaque Bond
A1/D-size, Color CAD drawing, HP Opaque Bond
A1/D-size, Color images, Photo Paper
*medium density E/A0-size CAD print
General warranty statement
One year onsite warranty