|| Rate this content|
HP Designjet 1055CM Printer - Product Specifications
Localization of introduction
Serial number location
The serial number is located on the back cover.
The HP Designjet 1055CM printer is a high-performance, high-speed, 36-inch, large-format printer using thermal Inkjet technology. Its new ink system (printhead + printhead cleaner + ink cartridges) provides 600 dpi and 350/175 cc of ink in a continuous refill system.
HP Jetdirect card
The 1055CM printer has HP Jetdirect 600 N 10/100 TX (J3113A) installed.
NOTE: The Adobe PostScript drivers supplied with this printer are for Macintosh and Microsoft Windows operating systems only, and not for UNIX applications. Most UNIX applications that output PostScript files include embedded PostScript drivers.
With any queries about whether an application supports this printer or with any output problems that may be linked to a UNIX PostScript driver, first check software documentation and, if necessary, contact the software vendor for advice.
The following cables are recommended for optimum performance and electromagnetic compatibility:
Cables for PCs
Cables for UNIX systems
The fonts print shows all resident PostScript fonts (internal and downloaded) with a printed sample of each font.
NOTE: Asian versions ship with Asian fonts preloaded on the hard disk drive.
The HP Designjet 1050C printer accommodates all standard and odd paper sizes. The width ranges from 210 mm to 917 mm (8.3 to 36.1 inches). The maximum sheet length is 1600 mm (63 inches).
NOTE: See also the Supplies Source catalog and (in Europe and USA) the HP Paper Guide for the HP Designjet Printers.
New paper types may become available. For up-to-date information, contact an HP dealer or local HP sales and support Office.
The ink system in the 1055CM printer includes three components: a printhead, printhead cleaner, and an ink cartridge to provide large-capacity ink, unattended printing, ease of use, reliability, and low cost. The ink system offers true 600 dpi and advanced dithering algorithms for exceptional image quality prints.
Each 600 dpi thermal Inkjet printhead applies ink droplets onto paper and has a reservoir that holds enough ink for several prints. The printer automatically refills the printhead from the ink cartridge whenever the ink volume in the printhead reservoir becomes low. The printer uses the printhead cleaners to clean and maintain the printheads, to ensure best possible image quality, and to seal the printheads when they are not in use to ensure long life.
HP80 Ink supplies
The ink system components (the printhead, printhead cleaner, and ink cartridge) are called the HP80 Ink Supplies, and they are coded with an HP80 icon to help to reorder the correct replacement components.
Each color ink cartridge (cyan, magenta, yellow, and black) can be purchased separately from an HP retailer and should be purchased when an existing ink cartridge is low on ink, if you intend to print continuously.
The printhead and printhead cleaner are supplied as a single unit and should always be installed as a matched pair. They do not require replacement every time a new ink cartridge is installed in the printer. It is only necessary to replace the printhead/printhead cleaner when the existing components are time expired.
Part numbers for the HP80 Ink Supplies are listed in the table below.
The 1055CM printer comes with a 2.1 GB hard disk drive and 32 MB of memory. You can expand the memory up to 128 MB by adding additional 16 MB, 32 MB, or 64 MB memory expansion modules.
0.38 mm (0.015 inches) or 0.2 percent of the specified vector length, whichever is greater, at 23 degrees C (73 degrees F), 50 to 60percent relative humidity on HP special polyester film
Programming languages supported
NOTE: If the printer temperature falls below the minimum specified operating temperature the printer may stop to protect the ink systems.
At 3000 meters altitude, the printer may have operational problems.
General Warranty Statement
 Product exhibits Class A operation when connected to LAN cables using Print Server accessories.
To obtain a Material Safety Data Sheet (MSDS)
You can obtain current Material Safety Data Sheets for the ink systems used in the printer via the HP Web site (www.hp.com).
Electromagnetic Compatibility (EMC)
The US Federal Communications Commission (in 47 cfr 15.105) has specified that the following notice be brought to the attention of those using this product.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
CAUTION: Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not expressly approved by the Hewlett-Packard Company, may cause harmful interference and void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interferences by one or more of the following measures:
You may find useful the following booklet prepared by the FCC: "How to Identify and Resolve Radio-TV Interference Problems." This booklet is available from the US Government Printing Office, Washington, DC 20402, and Stock No. 004-000-00345-4.
Use of shielded data cables is required to comply with the Class B limits of Part 15 of the FCC Rules.
When connected to LAN cables using print server accessories
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense.
DOC statement (Canada)
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
When connected to LAN cables using print server accessories, this digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
The HP Designjet 1050C and 1055CM printers, models C6074 and C6075, are approved under Approval Number NS/G/1234/5/100003 for indirect connection to public telecommunication systems within the United Kingdom.