Print | Rate this content

HP Deskjet 450 Mobile Printer series - Bluetooth Hardware Setup and Testing

Bluetooth Setup

  1. Look at the back of the DeskJet 450 printer. In between the Parallel and USB adapter slots, you will find a slot for a Compact Flash card as seen in Figure 1.

  2. Hold the HP or ANYCOM printer card by the blue area on the antenna and insert it into the slot on the slot of the DeskJet 450 with the label facing upward.

    Figure 1: Card slot

  3. Do a TAP TEST # 4 to check the version of the Firmware. Print the diagnostic page to view the current firmware version information by doing the following:
    1. With the printer on and in a Ready state, press and hold down the POWER button.
    2. While holding down the POWER button, press the RESUME button four times.
    3. Release the POWER button to start printing the Diagnostic page. The Printer Information section of this page lists the firmware revision as "FW Revision."
    HP Deskjet 450 Diagnostic Information
    Product
    Manufacturer: HP
    Product Name: dj450
    Serial Number: sg00000000
    Service Id: 08211
    FW Revision CF00088Y (Needs to have firmware DF00500V or later)
    If you do not have the correct firmware, the following pages may not print out.
  4. Do a TAP TEST # 4 to check the status of the Bluetooth Device. Print the tap test # 4 by doing the following:
    1. With the printer on and in a Ready state, press and hold down the POWER button.
    2. While holding down the POWER button, press the RESUME button four times.
    3. Release the POWER button to start printing the Diagnostic page. The Printer Information section of this page lists the firmware revision as "FW Revision."
    Desk jet 450 Configuration Information
    Bluetooth Connectivity
    BT Device Name : Win BIJ 450
    Status : Inactive
    BT Device Address : 00:90:02:05:10:80 00
    10 05 02 90 A9 80 10 05 02 90 80 10 05 02 A0
    Mode: Public Authentication: Off Encryption : Off
  5. Do a TAP TEST #4 to check to see if the printer recognizes the card. Print the tap test # 4 by doing the following:
    1. With the printer on and in a Ready state, press and hold down the POWER button.
    2. While holding down the POWER button, press the RESUME button four times.
    3. Release the POWER button to start printing the Diagnostic page. The Printer Information section of this page lists the firmware revision as "FW Revision."
    Desk jet 450 Blue tooth Configuration Information
    Blue Tooth Device Name : Win BIJ 450
    Blue Tooth Device Address: 00:90:02:05:10:80
    00 10 05 02 90 A9 80 10 05 02 90 80 10 05 02 A0
    Mode : Public
    Authentication : Off
    Encryption : Off
    Number of Bonded Devices : 0
    Additional Keys Available : 8

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!