Print | Rate this content

HP LaserJet P2015 Series Printer - Clean the pickup roller (tray 2)

  1. Unplug the power cord from the printer, and allow the printer to cool.

  2. Press the print-cartridge-door button, and then remove the print cartridge from the printer.

    After removing the print cartridge, only handle it on the ends.
  3. Remove tray 2.

  4. Open the automatic two-sided path door on the front of the printer (HP LaserJet P2015d, HP LaserJet P2015dn, and HP LaserJet P2015x printers only).

  5. Place the printer on the work surface with the front of the printer facing up.

  6. Pull the white tabs outward, and rotate the tabs up.

  7. Slide the right tab to the right, and leave the tab in this position throughout the procedure.

  8. Slide the pickup roller assembly to the right, and remove the left end cap.

  9. Remove the pickup roller.

    Do not touch the pickup-roller pad.
  10. Dab a lint-free cloth in water, and scrub the roller.

  11. Using a dry, lint-free cloth, wipe the pickup roller to remove loosened dirt.

  12. Allow the pickup roller to dry completely.

  13. Insert the left side of the pickup roller into the left slot (1), and insert the right side (the side that has the notches in the shaft) into the right slot (2).

  14. Place the end cap over the shaft on the left side, push the end cap to the right, and rotate the tab downward into position.

  15. Rotate the shaft until the notches engage and the shaft clicks into place.

  16. Push the right tab to the left, and rotate the tab downward into position.

  17. Place the printer on the work surface with the top of the printer facing up.

  18. Close the automatic two-sided path door.

  19. Reinstall the print cartridge, and close the print-cartridge door.

  20. Plug the printer in.

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!