Print | Rate this content

HP Deskjet D4360, D4363, and D4368 Printers - Setting Up the Product (Hardware)

Introduction

This document explains how to set up the physical parts of the product. Complete these steps before you install the product software on your computer.

Set up the product

Follow these steps in order.

Step one: Unpack the product

  1. Remove all the tape and orange packing material from the product.

    Figure 1: Remove tape and packing material

    Remove tape and packing material
  2. Lower the paper tray.

    Figure 2: Lower the paper tray

    Lower the paper tray
  3. Open the cover and remove the packing material from the inside of the product.

    Figure 3: Open the cover and remove the packing material

    Open the cover and remove the packing material
  4. Close the cover.

    Figure 4: Close the cover

    Close the cover

Step two: Connect the power cord and adapter

  1. Connect the power supply to the back of the product.

  2. Connect the power cord to the power supply.

  3. Connect the power cord to an electrical outlet.

    Figure 5: Connect the power cord and adapter

    Connect the power cord and adapter
    1 - Connect the power supply to the product.
    2 - Connect the power cord to the adapter.
    3 - Connect the power cord to an electrical outlet.

Step three: Turn on power

  1. Press the Power button () to turn the product on.

    Figure 6: Power button location on the product

    Power button location on the product

Step four: Load plain paper

  1. Raise the output tray.

    Figure 7: Raise the output tray

    Raise the output tray
  2. Slide the paper width guide to the left, and then load a stack of plain paper in the input tray.

    Figure 8: Adjust the paper guide and load paper

    Adjust the paper guide and load paper
  3. Slide the paper width guide to the right until it rests firmly against the paper.

  4. Lower the output tray, and then pull out the tray extension.

    Figure 9: Pull out the tray extension

    Pull out the tray extension

Step five: Install the cartridges

NOTE: The exterior of the product varies by model. The product might not match the product in the animation, but the procedure is the same.
  1. Open the cover.

    Figure 10: Open the cover

    Open the cover
  2. Wait until the carriage moves to the right side of the product and is idle.

  3. Remove the cartridge from its packaging, and then pull the pink tab to remove the tape from the cartridge.

    Figure 11: Remove the protective tape

    Remove the protective tape
    CAUTION: Do not touch the ink nozzles and copper contacts on the cartridge. Touching these parts can result in clogs, ink failure, and bad electrical connections. Do not remove the copper strips. They are required electrical contacts.

    Figure 12: Do not touch the ink nozzles or copper contacts on the cartridge

    Do not touch the ink nozzles or copper contacts on the cartridge
    1 - Ink nozzles
    2 - Copper contacts
  4. Hold the cartridge so that the copper strips are on the bottom and facing toward the product.

  5. Slide the cartridge at a slight upward angle into the carriage until the cartridge snaps into place.

    Figure 13: Insert the cartridge

    Insert the cartridge
    • Install the tricolor cartridge on the left side of the carriage.

    • Install the black cartridge on the right side of the carriage.

  6. Close the cover.

    Figure 14: Close the cover

    Close the cover

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!