Print | Rate this content

HP T750 G2, T1000 G3 and T1500 G3 Uninterruptible Power Systems - Replace the Battery

Introduction

This document is provided to assist in replacing the Battery for the HP T750 G2 T1000 G3 and T1500 G3 Uninterruptible Power System.

top

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

top

Parts required

NOTE: Part numbers are subject to change.

The replacement part number will vary depending on the Battery that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP .

Description
Part Number
Requires Return
T750 UPS battery module
502538-001
Yes
T1000 UPS battery module
502539-001
Yes
T1500 UPS battery module
502540-001
Yes
NOTE: For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

top

Summary of instructions

To view a video demonstrating the procedure for replacing the Battery, click on the link below. Or use the product video listing on the HP Services Media Library , then select Battery replacement from the menu on the upper left hand side of the screen.

Click here to view the Battery replacement video (right-click on the link to open in a new window/tab).

Battery replacement

  1. Place the new battery pack on the flat, stable surface with the battery terminals at the top.

  2. Connect the black battery cable to the new battery.

  3. Slide the batteries into the UPS. For the HP T1500, be sure to tuck the black cable connector between the middle and back batteries to prevent damage.

  4. Connect the battery cables.

    NOTE: A small amount of arcing may occur when connecting the batteries. This is normal and does not damage the unit or present any safety concern.
  5. Replace the metal battery cover and the UPS front bezel.

top

Parts return

If your part requires return then click on the appropriate link below:

Click here for the defective parts return procedure for US .

Click here for the defective parts return procedure for Europe .

top

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!