HP LaserJet 1020 and 1022 Printer Series - Setting Up the LaserJet (Hardware)
This document explains how to set up the physical parts of the product. Complete these steps before you install the product software on your computer.
This document includes the following steps to set up the product:
Follow these steps in order.
Remove the product from the box.
Figure 1: Remove the product from the box
Check the contents of the box.
The contents might vary by country/region. See the packaging for a list of items shipped in the box.
Open the print cartridge access door.
Figure 2: Open the print cartridge access door
Remove all the orange packing tape from the product.
Figure 3: Remove the orange packing tape
Open the output tray support, and then open the print cartridge door.
Figure 4: Open the output tray support
Figure 5: Open the print cartridge door
Remove the new print cartridge from the package.
CAUTION: Hold the print cartridge at each end to prevent damage to the print cartridge.
Figure 6: Remove the new print cartridge from the package
Gently rock the print cartridge
back and forth to distribute the toner evenly.
Figure 7: Rock the print cartridge
back and forth
Pull the orange tab until all the sealing tape is removed from the print cartridge. Put the tab in the print cartridge box to return for recycling.
Figure 8: Pull the orange tab to remove the sealing tape
Insert the print cartridge in the product, and then close the print cartridge door.
Figure 9: Insert the print cartridge
Connect the power cord to the back of the product, and then plug the power cord into an electrical outlet.
Figure 10: Connect the power cord
Press the Power switch to turn on the product.
Figure 11: Press the Power switch
Slide the paper width and length guides to their outmost positions.
Figure 12: Slide out the paper guides
Load the paper into the paper tray, and then slide the paper width and length guides inward until they stop at the edge of the paper.
CAUTION: Do not use stapled, wrinkled, folded, or damaged paper.
Figure 13: Load the paper and slide in paper guides
Insert the input tray cover over the main input tray.
Figure 14: Insert the input tray cover
Close the input tray.
Figure 15: Close the input tray