Print | Rate this content

HP ProCurve LAN Switches - Multi-user 802.1X Enhancements

Information

The standard IEEE 802.1X implementation assumes a single edge node is attached to a given port. Any successful authentication will open the port to any and all traffic. If a multiport access device such as a hub, switch or Wireless Access Point is connected to the 802.1X controlled port, then the port would be opened to all users of the multiport device after a single user or device successfully authenticated. This is commonly referred to as "Port-based authentication".

Details

HP ProCurve offers an enhancement to 802.1X known as Multi-user or “Multiple 802.1X User Authentication Per Port”. The feature was first introduced with the E.09.01 code version for the HP ProCurve Switch 5300xl series. Multi-user 802.1X is now available on most feature-line ProCurve switches introduced or updated since 2005. Check the documentation for the product in question in order to verify support for this feature.

Multi-user 802.1X allows for independent authentication of upto 32 separate users on each port. Users sharing an uplink through a multiport device are no longer permitted to access the network without their own successful authentication. Details on configuration and operation of Multi-user 802.1X appear in the Access and Security Guides for the products within which the feature is available. The section in the manual is typically titled “802.1X User-Based Access Control” .

Reference:

Please refer to HP public website in the “Ask ProCurve (Knowledge Base)” of an article titled “HP ProCurve Switches – Multi-user 802.1X Enhancements (KB001522)” at the following URL:

Click here to access the “Ask ProCurve (Knowledge Base)” web page Non-HP site .

NOTE: The above-mentioned URL will take you to a non-HP Web site. HP does not control and is not responsible for information outside of the HP Web site.

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!