Print | Rate this content

Compaq 610 Notebook PC - Removing and Replacing Optical Drive

Introduction

This document is provided to assist in removing and replacing the optical drive for the Compaq 610 Notebook PC.

top

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

top

Tools required

  • Small, Phillips-head (P00 and P1) screwdrivers

  • Small Torx T8 screwdriver

  • Small, flat-bladed screwdriver or a flat-bladed alignment tool

top

Parts required

NOTE: Part numbers are subject to change.

The replacement part number will vary depending on the optical drive that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP .

Description
Part Number
Requires Return
DRV ODD SATA DVD SM
538406-001 (Modified)
Yes
DVD±RW Super Multi Double-Layer combination drive with LightScribe - 12.77 mm tray load - Includes bezel and bracket
538442-001 (Modified)
Yes
DRV ODD SATA DVD-RO
575200-001 (Modified)
Yes
DVD-ROM drive - SATA interface, 12.7 mm tray load - Includes bezel and bracket - For use only on computer models equipped with an Intel processor
538441-001 (Modified)
Yes
Optical drive connector board
538460-001 (Modified)
No
NOTE: For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labelled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labelled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

top

Summary of instructions

To view a video demonstrating the procedure for removing the optical drive, click on the link below. Or use the product video listing on the HP Services Media Library ( Click here to go to HP Service Media Library ), then select Optical drive from the menu on the upper left hand side of the screen.

Click here to view the optical drive removal video (right-click on the link to open in a new window/tab).

Optical drive removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:

    Click here to view the precautions .

    CAUTION: Failure to comply with the precautions could result in damage to your product or loss of data.
  2. Remove the battery. Click here for instructions on how to remove battery .

  3. Remove the 7mm P1 Phillips-head screw that secures the optical drive to the bottom of the base enclosure.

  4. Use a small, flat-bladed tool to push out on the metal tab on the rear of the optical drive to partially eject it from the base enclosure.

  5. Grasp the optical drive bezel and pull the optical drive out of the base enclosure.

Optical drive replacement

  1. Insert the optical drive into the base enclosure until the connector is seated.

  2. Replace the 7mm T8 Torx screw that secures the optical drive to the bottom of the base enclosure.

  3. Replace the battery. Click here for instructions on how to replace battery .

top

Parts return

If your part requires return then click on the appropriate link below:

Click here for the defective parts return procedure for US .

Click here for the defective parts return procedure for Europe .

top

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!