Print | Rate this content

HP Pro 3000 Microtower PC - Removing and Replacing the Memory

Introduction

This document is provided to assist in removing and replacing the memory for the HP Pro 3000 Microtower PC.

top

Minimum skill level

The End User requires no hardware-specific training to replace the defective part. The End user should have familiarity with system hardware and software requiring repair.

top

Tools required

Torx-15 screwdriver

top

Parts required

NOTE: Part numbers are subject to change.

The replacement part number will vary depending on the memory that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP .

Description
Part Number
Requires Return
1GB, 1333MHz, PC3-10600, 240-pins, non-ECC, unbuffered DIMM
576109-001 (Modified)
Yes
2GB, 1333MHz, PC3-10600, 240-pins, non-ECC, unbuffered DIMM
576110-001 (Modified)
Yes
4GB, PC3-10600, DDR3-1333 MHz, 240-pins, non-ECC, unbuffered DIMM (Dual In-Line Memory Module)
585157-001 (Modified)
Yes
NOTE: For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labeled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labeled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

top

Summary of instructions

To view a video demonstrating the procedure for removing the memory, click on the link below. Or use the product video listing on the HP Services Media Library, ( Click here to go to HP Service Media Library ) then select Memory from the menu on the upper left hand side of the screen.

Click here to view the memory removal video (right-click on the link to open in a new window/tab).

Memory removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:

    Click here to view the precautions .

    CAUTION: Failure to comply with the precautions could result in damage to your product or loss of data.
    NOTE: This procedure applies to HP Pro 3000, 3125, and 3130 Microtower PCs. The HP Pro 3125 system is shown here.
  2. Remove the access panel. Click here for instructions on how to remove the access panel .

  3. Push down and out on the memory socket latches to release the memory module.

  4. Pull the memory module up and out of the socket.

Memory replacement

  1. Ensure that the memory socket latches are pushed down and away from the memory socket.

  2. Match the notch on the memory module with the key in the memory socket.

  3. Push the module down firmly into the socket until the latches snap into place and the module is fully seated.

  4. Replace the access panel. Click here for instructions on how to replace the access panel .

top

Verifying successful repair

Power on the server and verify that the BIOS memory and processor messages are displayed on the monitor during the boot process.

top

Parts return

If your part requires return then click on the appropriate link below:

Click here for the defective parts return procedure for US .

Click here for the defective parts return procedure for Europe .

top

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!