Print | Rate this content

HP Compaq 8200 Elite Small Form Factor PC - Removing and Replacing the Power Supply

Introduction

This document is provided to assist in removing and replacing the power supply for the HP Compaq 8200 Elite Small Form Factor PC.

top

Minimum skill level

The End-User must possess extensive product-specific knowledge and technical skill on how to service the system, and be familiar with the operating system.

top

Parts required

NOTE: Part numbers are subject to change.

The replacement part number will vary depending on the power supply that is being replaced. If a part is listed as "Yes" under "Requires Return" then the defective part needs to be returned to HP. Click here for more information on returning parts to HP .

Description
Part Number
Requires Return
Power supply (240 W)
613763-001 (Modified)
Yes
Power supply assembly (240 W)
613762-001 (Modified)
Yes
NOTE: For customers in countries/regions with RoHS legislation* (e.g. EU, China, etc.) restricting the use of hazardous substances in electrical equipment. The use of the Original Spare part is regulated by RoHS legislation. If your unit contains a part that is labeled with the Modified Spare number, the Modified Spare must be ordered as the replacement part. If your unit contains a part that is labeled with the Original Spare number, please order the Original Spare as the replacement part. In this case either the Original Spare or the Modified Spare may be shipped which will not affect performance or functionality of the unit.

top

Summary of instructions

To view a video demonstrating the procedure for removing the power supply, click on the link below. Or use the product video listing on the HP Services Media Library ( Click here to go to HP Service Media Library ), then select Power supply from the menu on the upper left hand side of the screen.

Click here to view the power supply removal video (right-click on the link to open in a new window/tab).

Power supply removal

  1. Review the safety considerations before performing the steps listed below by clicking on the following link:

    Click here to view the precautions .

    CAUTION: Failure to comply with the precautions could result in damage to your product or loss of data.
  2. Remove the access panel. Click here for instructions on how to remove the access panel .

  3. Rotate the drive cage to the up position.

  4. Rotate the power supply to the up position.

  5. Disconnect the power cables from the system board, noting their location for reinstallation.

  6. Rotate the power supply slightly inward and then pull forward to move the guide pins out of the curved channels in the mounting bracket into the vertical channels.

  7. Lift the power supply up and out of the mounting bracket.

Power supply replacement

  1. Position the power supply with the guide pins over the channels in the mounting bracket.

  2. Slide the power supply down and then back toward the rear of the chassis until the guide pins enter the curved channel.

  3. Connect the power cables to the system board.

  4. Rotate the power supply to the down position.

  5. Rotate the drive cage to the down position.

  6. Replace the access panel. Click here for instructions on how to replace the access panel .

top

Parts return

If the part requires return then click on the appropriate link below:

Click here for the defective parts return procedure for US .

Click here for the defective parts return procedure for Europe .

top

Provide feedback

Please rate the information on this page to help us improve our content. Thank you!